Note: The chip of GOKU GM10 V3 GPS is M1005. Only BF4.3x version firmware can use Ublox protocol. BF4.2x and earlier firmware can only use NMEA protocol But there is no difference in performance between the two protocols
GOKU GM10 V3 GPS series is here! Using the latest M10050 GNSS chip. Compared with the previous generation GM8 V2, the positioning is more accurate, and the speed of star search is faster.
Description Brand: FLYWOO Model: GM10 PRO V3 GPS w/ Compass Dimension : 25mm*25mm*6mm Weight : 7.3g Connector : 1.00mm spacing between the 6pins patch seat
Features: GPS Module,Three Module Compass With electronic compass IC QMC5883L 1.0mm spacing between the 6pins patch seat
Data and Update Rate Support Rate : 4800bps to 921600bps,Default 115200bps Data Level : TTL or RS-232,Default TTL level Data Protocol : BF4.3.X(UBLOX)/BF4.2.X(NMEA) Output frequency : 1Hz-10Hz,Default 10Hz
Operational Limits Altitude : 50,000m Max Velocity : 500m/s Max Acceleration : Less than 4g
Power consumption VCC : DC Voltage :5V Operating temp : -40 °C ~ +85°C Storage Temp : -40°C ~ +105°C
Indicator : PPS LED:yellow .PPS LED not bright when GPS not fixed,flashing when fixed The Module’s Pins: TX RX GND 5V SCL SDA
Includes 1x GM10 PRO V3 GPS w/ Compass 1x 150mm Cable 1x Copper Foil
Some of the best GPS units I've used in this hobby. Very fast lock even a cold start and acquire 30 satellites easily.
J
Joe
A shockingly great experience
This GM10 GPS/Compass works better than many of my more expensive GPS/Compass Matek hardware. Far more sat locks then expected 15-18 Sats, that was a sock with how low a price this unit cost. I'm going to replace a few of my Matek GPS units with these and get a couple of extra's to have on hand.
G
Guillermo Gaeta
Next build
Espero usarlo en mi próxima construcción
j
jim
great little gps
I had to replace a matek gps after a crash with this unit I now get over 10 sats in the house. I will be using more in the future
Good flier, handles the abuse a new flier like me has put it through
First prebuild from NBD. I swapped out the tracer RX for crossfire, initially had a no gyro flag on the AIO but was able to get it sorted with NBD support. Flying it is a good time and it’s held up well to some decent crashes. So far only thing(s) I’ve needed to replace has been a propeller and a M3x20 standoff. Took me too long to notice but the 2 aluminum pieces are for taking the O3 air unit from 25x25 mounting and making it 20x20.